Thanks to Rick at HT Coatings for the clarification on the two red wires to
the voltage regulator from the harness. I have repaired that and still could
not start the car so I went through a progression of changing something and
then trying to start the car. I changed out the coil, rotor cap, distributor
and still no starting.
I tested all the fuses and verfied they were OK. All electical appears to be
fine.
Any other suggestions? Secret safety device that will allow the engine to
crank and not start? I had not had an issue like this where everything worked
and the car would not start. I had the fusible link at the ammeter issue, but
nothing would work when that occured.
Greg 0036
|