Re: Upper Timing Chain Tensioner - '68 2000

[roadster68 <roadster68@shaw.ca>]

I tried to measure the head thickness.  I thought it was a little awkward
with the head on the block.  I am not that smooth w/ a micrometer either.
As best I could tell the average of several thicknesses worked out to be
about 4.480 inches.  The number 4.528 is the one that I have seen most for a
stock head.  This is a difference of 0.048 inches.  Did I get a good
measurement and if yes, then is my number very far off stock?  Larry.