Congratulations for doing the job right....good-oh.
----- Original Message -----
From: Henry Frye <thefryes@iconn.net>
To: R. Kastner <kaskas@earthlink.net>
Cc: <fot@autox.team.net>
Sent: Thursday, March 23, 2000 2:51 AM
Subject: Re: A couple questions
> At 07:17 AM 3/22/00 -0800, R. Kastner wrote:
> >That's really very cool that you have a machinest that is helpful. I
hope
> >you remember to have the big end resized after you increase the torque
cause
> >the big end will definatly be out of round.
>
> big snip
>
> Sure enough, all 8 rod bolts had that special moly grease on them, got
> torqued up and were resized. I didn't have to ask, they just did it. Two
of
> the big ends showed a tiny bit of material removed, the other two showed
> just a trace removed. Yup, I'm gonna keep these guys! We will see how
> everything turned out today, I hope.
> Henry Frye thefryes@iconn.net
> http://members.iconn.net/~thefryes/amici.html
> For The Street - TR3B TR250 Stag
> Not For The Street - TR4
>
|