Leon your push rod lenght will be determind buy your rocker geomitry If the
head has been modified the stock rods could be a little long The tip of
the rocker should ride on the center of the valve stem, I hope other
members will correct me or perhaps state it correctly rob
----- Original Message -----
From: <GuyotLeonF@aol.com>
To: "FOT" <fot@autox.team.net>
Sent: Sunday, December 02, 2001 9:08 AM
Subject: 6 cylinder pushrod length required
> Friends,
>
> I require the length of an engine pushrod:
>
> It is part # 151073 as found in the Vitesse Mk.2 engine, also the GT6-2,
and
> GT6-3 [up to KE/KF10000].
>
> but NOT part # 129058 from the Vitesse 6, 2-Litre Mk.1 or GT6-1.
>
> nor part # 149513 from GT6-3 [from KE/KF10001], Triumph 2000 Mk.2, TR6
[all
> CP models]
> (this one is 20.6 cm, or 8.11" long, to the end of the 'ball').
>
> nor part # 148916 from TR6 [all CR models]
> (this one is 21.1 cm 8.30" long).
>
> Could anyone please confirm the length of 151073 ?
>
> Thank you in advance
>
> Leon
|