Re: Intake manifold ... ceramic coatings

[Rikrock@aol.com]

In a message dated 10/11/05 7:00:30 PM Eastern Daylight Time, 
oldskooling@yahoo.com writes:
I know some of you run heat sheilds that go up along the bottom side of the 
intake manifold, but I would think ceramic coating would work better, and also 
save weight. Anyone care to share there thoughts on this?
-Bob Adams


I chose the easy way out.  I use (really good) heat reflective material on 
the bottom half of the intake runners.

Rich Rock
pottstown, PA