Re: RE: Boring Liners-Sharing Info & Experience

[Gasket Works USA <gasket.works@gte.net>]

I can see an Aluminum fixture say six inch square attached to a stout mill.  
This would be bored to accept the liner, height to be adjusted by shims under 
the liner where the "fig of 8" gasket seals go. The top of the fixture has six 
7/16" tapped holes where a miniature single cylinder torque plate fixes the 
liner under load.  A multiple indexed boring head to make the bore to undersize 
then honed.

md   


===  unsubscribe/change address requests to majordomo@autox.team.net