healeys
[Top] [All Lists]

Re: Looking for parts

To: "Ron Fine Esq." <ronfineesq@earthlink.net>, <healeys@autox.team.net>
Subject: Re: Looking for parts
From: "Robert Poague" <rapoague@gte.net>
Date: Mon, 19 Apr 2004 13:15:24 -0700
Ron,
You may be looking at an old catalog. I just recently ordered and received
two distributor seals, PN 520-280 -- $5.15 each, from Moss. Can't help on
the other part.
Bob
BJ7

----- Original Message -----
From: "Ron Fine Esq." <ronfineesq@earthlink.net>
To: <healeys@autox.team.net>
Sent: Monday, April 19, 2004 9:45 AM
Subject: Looking for parts


> I am looking for a source for several parts:
> 1.    There is an metal backed pressed fit rubber oil seal at the top of
the
> distributor housing.  Moss shows it as part #520-280 and NA.
>
> 2.    There is a small metal piece that attaches to a intake manifold stud
on
> the bottom end and the top end has a hold to attach a spring clip holding
the
> water temp. capillary line.  I think there are two of these stand off
pieces,
> one at the front and one at the rear of the engine.  Moss shows it as part
> #725020  NA.
>
> Does anyone know of a source for either of these items.  I could fabricate
the
> standoff but the seal should be available somewhere.  If I knew the size I
> could probably get it from my local machine shop but getting the original
out
> will certainly destroy it for measurements.
>
> Any information is always appreciated.
> Ron Fine
> 61BN7





<Prev in Thread] Current Thread [Next in Thread>