healeys
[Top] [All Lists]

Vin plate paint

To: <healeys@autox.team.net>
Subject: Vin plate paint
From: "davidwjones" <davidwjones@cox.net>
Date: Tue, 19 Apr 2005 22:43:54 -0400
Patton,
You could also wait until the paint is completely dry, and use a couple of
drops of thinner on the newspaper in the procedure below, before gently
rubbing the plate on it until the unwanted sections of paint are removed.
  ----- Original Message -----
  From: davidwjones
  To: Patton Dickson ; healeys@autox.team.net
  Sent: Tuesday, April 19, 2005 7:33 PM
  Subject: Re: engine number plate


  Patton,
  My VIN plate was much like yours, the metal was fine, but the paint was
shot.
  You will notice that the black painted areas are recessed slightly.
  What I did with mine, was to stretch 2 or three thicknesses of newspaper
TIGHTLY over the edge of a table. The edge was very sharp and straight. Then I
thinned some black paint out to as thin as could be and still get coverage. I
painted the whole front face of the plate, then carefully wiped off the "high
spots" on the newspaper covered table-edge. You can do that, or if the paint
was thin enough, you can wait until it is quite dry, then vigorously rub off
the high spots on the table edge. --It worked great for me.
  If you use too much "padding" by using too many layers of paper, it will
take paint off that you don't want to. ---And if you mess up, you can always
wipe the plate with thinner, and start over.
  It is easier to manipulate the painted plate if you attach some kind of
temporary adhesive handle to the back.

  David W. Jones
  '62 Mk II BT7 tricarb
  Cumberland, RI USA

    ----- Original Message -----
    From: Patton Dickson
    To: davidwjones
    Cc: healeys@autox.team.net
    Sent: Tuesday, April 19, 2005 6:08 PM
    Subject: Re: engine number plate


    I am talking about the painted part of the firewall plate, I meant to
    specify that :(...  the metal is perfect on mine, the painted area is
    faded badly.  I would think a transfer could be made to replace the
    bad paint.

    Patton

    On 4/19/05, davidwjones <davidwjones@cox.net> wrote:
    > Decal?
    > The engine plate is stamped. The firewall plate is painted then
stamped.
    --
    Patton Dickson - Richmond, TX
    '57 A-H 100-Six - http://Austin-Healeys.com




<Prev in Thread] Current Thread [Next in Thread>
  • Vin plate paint, davidwjones <=