healeys
[Top] [All Lists]

Re: BN1 Split Dash Question

To: craigsuerice@iquest.net, mlempert@bellsouth.net
Subject: Re: BN1 Split Dash Question
From: "WILLIAM B LAWRENCE" <ynotink@msn.com>
Date: Sun, 17 Jun 2007 03:48:08 +0000
I re-used the old piece too, but I think the rubber strip is the same 
profile as the one that goes between the lower front shroud and the the 
filler panel behind the bumper.

Bill Lawrence


> >
> > Date: Mon, 11 Jun 2007 14:08:49 -0500
> > From: "Craig and Sue Rice" <craigsuerice@iquest.net>
> > Subject: Re: BN1 Split Dash Question
> >
> > John,
> > An extruded rubber piece was located between the facia and instrument
>panel
> > on BN1's up to Body Number 1854 (Car/Chassis Number not known). My BN1,
>with
> > all of it's original sheet metal, purchased new by my Father, has this
> > rubber piece. Body Number 1457, Car/Chassis Number BN1L 150907 was built
>on
> > 14 January 1954. I'm using my original rubber piece. Don't know of any
> > sources except you might find a similar shape in a extruded rubber
>catalog.
> > Has anyone done this???????
> > Craig Rice
> > - ----- Original Message -----
> > From: "John Rued" <rudedoggg@earthlink.net>
> > To: "List Healey" <healeys@autox.team.net>
> > Sent: Sunday, June 10, 2007 9:47 AM
> > Subject: BN1 Split Dash Question
> >
> >
> > > Is there a rubber gasket-type piece that fits between the fascia and 
>the
> > > dash?  is there a source for that piece?
> > >
> > > Thank you,
> > >
> > > John Rued




<Prev in Thread] Current Thread [Next in Thread>