I would assume that the distance piece was added to add strength to
the spindle. Since the only spindles I have seen cracked have been
cars that did not have a spacer installed.
I would recommend installing the spacer that was added on the BN4
since they are the same spindle, hub and bearings it was done for a
reason. Probably the added weight and being a 6 cylinder car they may
have assumed that the owners may drive harder.
David Nock
British Car Specialists
Stockton Ca 95205
209-948-8767
www.britishcarspecialists.com
.
.
On Apr 7, 2009, at 10:32 AM, Rich C wrote:
> Hi Bob,
>
> When BN2's went to the taper roller bearing setup they did not have
> the distance piece fitted. Just follow the directions for setting
> up as described in the manual.
>
> Rich
>
> ----- Original Message ----- From: "Bob Spidell"
> <bspidell@comcast.net>
> To: <healeys@autox.team.net>
> Sent: Tuesday, April 07, 2009 12:19 PM
> Subject: [Healeys] Front wheel bearing 'distance piece'
>
>
>> Folks,
>>
>> Anyone know if BN2s had the front wheel bearing 'distance
>> piece' (spacer)? The Moss catalog only shows a part for BN4s on.
>>
>>
>> Bob
>> _______________________________________________
>> Support Team.Net http://www.team.net/donate.html
>>
>> Healeys@autox.team.net
>> http://autox.team.net/mailman/listinfo/healeys
>>
>> You are subscribed as richchrysler@quickclic.net
>>
>> http://www.team.net/archive
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as healeydoc@sbcglobal.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|