My apologies, Rich. I meant U.S. inches, not American inches!
--- On Sun, 7/5/09, HealeyRick <healeyrick@yahoo.com> wrote:
From: HealeyRick <healeyrick@yahoo.com>
Subject: Re: [Healeys] healey motor/gearbox measurements
To: "Linwood H Rose" <linwoodrose@mac.com>, "healeylist"
<healeys@autox.team.net>, "Rich C" <richchrysler@quickclic.net>
Date: Sunday, July 5, 2009, 6:12 PM
On my 29Dthe height from the lowest part of the oil pan to the top of the T
was more like 29", everything else matches Rich's dimensions. Perhaps Rich
was measuring height in Canadian inches and I was measuring in American
inches?
Rick
--- On Sat, 7/4/09, Rich C <richchrysler@quickclic.net> wrote:
From: Rich C <richchrysler@quickclic.net>
Subject: Re: [Healeys] healey motor/gearbox measurements
To: "Linwood H Rose" <linwoodrose@mac.com>, "healeylist"
<healeys@autox.team.net>
Date: Saturday, July 4, 2009, 11:48 AM
Lin,
A couple of weeks ago a good portion of the list members were heading to
Conclave!
- height from bottom of oil pan to top of T pipe on rocker cover 27"
- length from fan centre to engine back plate 33 1/2"
- length from fan centre to end of propshaft on gearbox/od 64"
- Width from distributor across to air cleaners approx. 25".
Rich Chrysler
----- Original Message ----- From: "Linwood H Rose" <linwoodrose@mac.com>
To: "healeylist" <healeys@autox.team.net>
Sent: Saturday, July 04, 2009 4:05 AM
Subject: [Healeys] healey motor/gearbox measurements
> Hi folks
> I posted this a couple of weeks ago without a response. Thought I would
try
one more time before I give up. Thanks!
>
>
> Does anyone have linear measurements for the engine with usual components
attached? Or, if there is a document like the frame "blueprint" you can
refer
me to, I would appreciate it. I am looking for things like height from
bottom
of oil pan at lowest point to the top of the rocker cover (or the vent "T"
pipe on the cover), depth from fan center to engine backplate, depth from
fan
center to end of the gearbox, width of the block and width from the air
cleaners to the distributor (widest point of the assembly).
>
> Thanks for sharing if someone has this information.
>
> Lin
> 1960 BT7 "The Bloody Beast"
> 1959 AN5 Bugeye
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
You are subscribed as healeyrick@yahoo.com
http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
You are subscribed as healeyrick@yahoo.com
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|