mg-t
[Top] [All Lists]

Re: Ethanol gas

To: lpalmer@roundaboutmanor.com, ddubois@sinclair.net
Subject: Re: Ethanol gas
From: PopeyMike@aol.com
Date: Tue, 8 May 2007 19:53:31 EDT
To avoid this problem, I installed a modern electric fuel pump cost  $20.00 
very close to the tank.  This supplier fuel to the original pump and  it does 
not have to work as hard - saving its life.  Also with that modern  filter it 
keeps all dirt out.
 
Runs great for 20 years now.
 
Michael Balahutrak
53 TD
 
 
 
In a message dated 5/8/2007 6:17:21 P.M. Central Daylight Time,  
lpalmer@roundaboutmanor.com writes:

Remember  the symptoms - incessant ticking. This indicates an inability to
gain  suction. If a pump STOPS ticking, then there is a blockage or an
inability  to deliver fuel, but incessant ticking indicates (most likely) an
air  leak.

Cheers,
Lew Palmer

-----Original Message-----
From:  owner-mg-t@Autox.Team.Net [mailto:owner-mg-t@Autox.Team.Net] On Behalf
Of  Dave and Liz DuBois
Sent: Tuesday, May 08, 2007 3:29 PM
To:  PopeyMike@aol.com
Cc: rddell@mindspring.com;  mg-t@autox.team.net
Subject: Re: Ethanol gas

>"...with a good  modern day screen filter installed in line downstream of
the
filter in  the
>tank..."
>
Off the subject of the sloshing compound, one  needs to keep a very close eye
on a filter placed between the tank and the  fuel pump. The filter in the
tank
is quite course in comparison to  modern day, high efficiency fuel filters
and
do not clog often with the  relative clean fuel available today.  The in line
filter is a  different story, it filter down to almost the submicron level
and
can  become clogged very easily.  When they become clogged, they will cut  off
flow to the fuel pump and cause it to stall in a current on  condition.  If
the
power is left on to the pump while  troubleshooting the problem it can easily
burn out th internal swampping  resistor, removing what little arc
suppression
is available on the early  low pressure or high pressure (in the case of
TFs).
The final result is  points that burn prematurely with replacement points
alos
burning much  quicker than they should.  If this should happen to one of
today's all  electronic fuel pump that Burlen Fuel Systems has made
available,
a  burned out swamping resistor will stop the pump  altogether.

Cheers,
Dave








///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-t

<Prev in Thread] Current Thread [Next in Thread>