mgs
[Top] [All Lists]

Re: Wheel Bearings

To: "Steve P." <mgbyellow@netzero.net>, <mgs@autox.team.net>
Subject: Re: Wheel Bearings
From: "Telewest \(PH\)" <paul.hunt1@blueyonder.co.uk>
Date: Fri, 30 Aug 2002 09:24:30 +0100
>From http://www.peevish.co.uk/slang/search.htm

SEARCH RESULTS 1 - 1 of 1 total results for doddle

A dictionary of slang - "D" - Slang and colloquialisms of the UK.
...doddle Noun. An easy task. {Informal}.

Get the shims from an MG parts supplier and ignore claims of 'you don't need
them' from anyone else, "You do in an MG" to mis-quote a well known phrase
or saying.  The inners and the races will fall out on the ground, the outers
are driven into the hub but a drift and a light hammer should be all that is
necessary to remove them, and the old outer (to ensure it goes in square)
and hammer to insert new ones.  IME the old shims have been correct for the
new bearings as the latter are very high precision items, but YMMV so have
some spares handy.  See http://www.mgb-stuff.org.uk and click on 'Spanners'
and 'Hubs' for my take on the full story.


----- Original Message -----
From: "Steve P." <mgbyellow@netzero.net>
To: <mgs@autox.team.net>
Sent: Friday, August 30, 2002 4:28 AM
Subject: Wheel Bearings


> ....  As Paul Hunt said in an
> earlier post "Tube axle hubs are a doddle to get off".  Not sure what he
> meant, but it was pretty straight forward and easy to do.
>
...
>
> What I don't understand is the shim thing.  Will the shims I take out with
the
> old bearings put the new ones back with the proper end float or should I
be
> prepared to use some other combination of shims.  I bought the new
bearings
> and seal at the local NAPA store and when I asked about shims they didn't
know
> what I was talking about.  Also, do the bearings have to be pressed in/out
by
> a machine shop or is it something I can do on my own with limited tools.

///  or try http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>