It's not so much sagging (if glued properly that shouldn't be an issue),
it's the funky raggedy-looking edges that I was objecting to.
on 7/26/04 1:30 AM, Paul Hunt at paul.hunt1@blueyonder.co.uk wrote:
> Same here on both my roadster and V8. Clausagers pictures of a roadster and
> C seem to show a similar gap, although not an inch, the V8 perhaps not.
> However if the felt went under the edges it would still sag in the middle
> while drying, and wouldn't leave space for the supporting laths I used to
> hold it in place while doing so.
>
> PaulH.
>
> ----- Original Message -----
> From: "Max Heim" <mvheim@studiolimage.com>
> To: "MG List" <mgs@autox.team.net>
> Sent: Friday, July 23, 2004 11:34 PM
> Subject: Re: Glue for under hood insulation
>
>
>> On the subject of underhood insulation, I would have thought that the
> panels
>> supplied by Moss would have been large enough to tuck up under the
> underhood
>> framing, in order to hide the edges for a neat appearance. Someone in this
>> thread also mentioned tucking in the edges. But the pieces I received were
>> far too small for this purpose -- probably left an inch exposed all the
> way
>> around. What's with that?
>
>
--
Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the primer red one with chrome wires
|