My question would be, how's your flywheel ring gear?
--
Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the primer red one with chrome wires
on 6/4/06 9:28 PM, Phil Bates at jello@ida.net wrote:
> Anyone fitted these to their cars?? I had my old inertia drive starter
> lock my engine tighter than a drum on saturday. Couldn't unlock it by
> trying to roll start or turn the shaft (it wouldn't turn) or anything.
> Luckily I was at a tire shop, and they very generously pushed me onto
> the lift, and helped remove the starter (which was not easy).
> Afterwards, it still wouldn't start the car (locked again, but not as
> hard this time, so I could roll start). So, I'm looking to replace the
> starter. That hi-torque unit looks appealing, although very expensive.
> I've read Barney's tech page, and the only experience there is that 2
> years ago they weren't all that great. So - anyone on the list have
> experience here???
>
> Phil Bates
> '67 MGB in need of reliable starting
> '58 MGA may get it next if all goes well.
|