> I am mostly finished with my project of building a blasting cabinet from
> TP Tools' parts kit
> and plans, and I am to the point where I have to cut the legs.
>
> Does anybody have any advice on how high the glove holes should be? It
> seems
> like they ought to be a little bit higher than elbow-height, but since I
> have no experience
> actually using a cabinet, I cannot say for sure...
Consider leaving the legs too long and trying it at different heights by
putting a platform you can move up and down in front of it (a bunch of 2x s
sitting on one or more layers of 2x shims). Cut the legs after you figure
out what works best for you and the type of blasting you do.
Mark.
|