Try Linatex Corp out of TN
I worked for them years ago, the number at that time was 800/546-2830
I don't know if that # still works.
-----Original Message-----
From: Bowen, Patrick A [mailto:PABowen@sar.med.navy.mil]
Sent: Friday, August 20, 1999 7:14 AM
To: Joe Curry; Ken C
Cc: spitfires@autox.team.net
Subject: RE: Light Gaskets
Joe, I have been waiting for someone to ask about this. I am the one that
took the project on but have unfortuneatly been shut down at every turn.
The last company I talked to wanted $6000 for the machining and $25 a piece.
I am still working the issue. Does anyone on the list know of a good
specialty rubber molding company I could try?
Thanks,
Patrick Bowen
-----Original Message-----
From: Joe Curry [mailto:spitlist@gte.net]
Sent: Thursday, August 19, 1999 5:22 PM
To: Ken C
Cc: spitfires@autox.team.net
Subject: Re: Light Gaskets
Ken, If you are talking about those Rubber Marker plinths (that the
pieces fit into, they are no longer available. However someone on the
list a while back was going to see about having new ones molded again.
I haven't seen any announcements, but perhaps it is in the works.
Anybody??????
Joe
Ken C wrote:
>
> Spitmaniacs,
>
> Any good sources for gaskets ? In particular, the left, right, front, rear
> (4 gaskets) for the side marker lights for a '72 Spit. Also need the
number
> plate (license plate) light gasket for the same car.
>
> Most of the rest of the gaskets can be locally fashioned, the above would
be
> difficult to make.
>
> TIA,
>
> Ken C
--
"If you can't excel with talent, triumph with effort."
-- Dave Weinbaum in National Enquirer
|