Graham Stretch wrote:
>
> Hi Mark
> I am assuming that is a smiths original tacho you have there, if it is, the
> round terminal 6.5mm (1/4") bullet is the one to connect to the coil. the
> flat terminal is usually connected to +12v it does not matter where the
> supply comes from , just don't get it from the light green that feeds the
> fuel and temp gauges as this is voltage stabilised to about 10v.
>
Actually, Graham, It DOES matter where the 12 volts is sourced. It
needs to come from a "switched" power source. The stock location is
from the input side of the Voltage stabilizer. This point is supplied
voltage only when the ignition switch is "ON".
Joe
--
"If you can't excel with talent, triumph with effort."
-- Dave Weinbaum in National Enquirer
|