...I would not think of doing it any way other than pull engine and tranny
as a unit...
If you are just doing a clutch, and are not fortunate enough to own an
engine hoist, pulling the whole engine/gearbox unit I would have thought
much more of a chore than pulling the 'box alone, which can be done with
basic tools, a jack, and a few muscles.
However, in Marv's case, I'd agree that it's best to mate it up before
installation.
Richard & Daffy
This email and any attached files are confidential and copyright protected.
If you are not the addressee, any dissemination of this communication is
strictly prohibited. Unless otherwise expressly agreed in writing, nothing
stated in this communication shall be legally binding.
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|