spridgets
[Top] [All Lists]

Re: attaching the hardtop

To: spridgets@Autox.Team.Net
Subject: Re: attaching the hardtop
From: Christopher Palmer <ctp@gbn.org>
Date: Fri, 23 Jan 1998 12:55:45 -0800
In-reply-to: <l03020901b0ecff5e09c7@[163.246.48.154]>
References: <34C758A7.57F2@hol.gr>
Reply-to: Christopher Palmer <ctp@gbn.org>
Sender: owner-spridgets@Autox.Team.Net
Howdy,

My hardtop is the same way.  When I got it, I had to tweak the front clamps
to even grab the brackets on the windscreen.  It had no rear clamping
parts, and I had to fashion my own side clamps from some stainless steel
turnbuckles (I don't know what was used originally).

Now that I have the 5 speed I can go even faster that before ('safety fast'
of course) and have had no problems with the hardtop.

CTP

>I suspect that the PO of my car had the same problem since the rear
>brackets are missing from my top. He drove the car 9 years with only the
>windscreen clamps and the side bolts holding the top on. What more do you
>need? I very rarely use the hard top, so it is less of an issue with me. I
>clamp the windscreen fasteners first, then do the side bolts. This usually
>means I don't use much force on the windscreen fasteners. Note that as with
>the soft top, clamping the hard top to the wind screen goes much better if
>you really pay attention to getting the front rubber piece seated correctly
>before applying pressure.
>
>Jeff
>
>>I have this odd problem when attaching the hardtop:
>>
>>If the rear locating brackets slide OK into their
>>respective body retainers then the front fasteners
>>fall a little bit "ahead" of their windscreen brackets!
>>
>>If I do the fasteners OK on the windscreen then the
>>rear locating brackets fall a little "behind" (about
>>half an inch) the retainers.
>>
>>What am I doing wrong? Is exerting super-human force
>>to the windscreen a normal part of the hardtop attaching
>>sequence so that everything falls into place?
>>
>>I end up doing the fasteners and side bolts and leaving
>>the rear locating brackets behind, because I'm scared
>>to push the windscreen forward. Is this ok?
>>
>>Finally, the hardtop has some considerable gaps (!) at
>>the windscreen header ends and the B-post tops but it
>>sure beats leaving the car in the soft top as no razor
>>blade can slash the metal hardtop, hopefully.
>>
>>Regards
>>Evangelos
>>66 Sprite MkIII
>
>
>
>_____________________________________________________MV
>
>Jeffrey H. Boatright, PhD
>Senior Editor, Molecular Vision
>http://www.emory.edu/molvis
>jboatri@emory.edu
>(404) 778-4113 Phone
>(404) 778-2231 FAX




<Prev in Thread] Current Thread [Next in Thread>