|To:||Dave_Vrba@mail.sel.sony.com, email@example.com, Metallian6@aol.com|
|Subject:||Re: Master cylinder question|
|Date:||Thu, 8 Apr 1999 12:11:17 EDT|
In a message dated 99-04-08 11:35:24 EDT, Dave_Vrba@mail.sel.sony.com writes: > Run taps through all the threaded holes to clean them out. Yup, good idea on all holes, and run a die over the bolts. This is especially important on anything torque critical, as the shmegma in the holes will give you a false toque reading on your wrench.
|<Prev in Thread]||Current Thread||[Next in Thread>|