spridgets
[Top] [All Lists]

Re: Warming Plate Gasket

To: Paul A Asgeirsson <pasgeirsson@juno.com>
Subject: Re: Warming Plate Gasket
From: Mike Maclean <macleans@earthlink.net>
Date: Mon, 29 Nov 1999 13:11:08 -0800
Cc: Spridgets@autox.team.net
References: <383ABB26.9B5AD779@earthlink.net> <19991123.083955.9751.4.PAsgeirsson@juno.com>
Reply-to: Mike Maclean <macleans@earthlink.net>
Sender: owner-spridgets@autox.team.net
Paul,
     Received the gasket in the mail today.  Never thought I'd see one this
side of the pond.
Thanks again.
Mike MacLean-60 Sprite

Paul A Asgeirsson wrote:

> Hi Mike,
>
> Are you talking about the gasket that's 2 1/4" X 2 1/8" with four stud
> holes in the corners made of reinforced asbestos material?  If that's it,
> I have one.  I'll stick it in the mail today if you want it.
>
> Send smail address to me.
>
> Paul
>
> PAsgeirsson@juno.com
>
> On Tue, 23 Nov 1999 08:04:55 -0800 Mike Maclean <macleans@earthlink.net>
> writes:
> >Before installing my stock exhaust manifold yesterday, I noticed the
> >gasket under the warming plate was not completely there.  I have not
> >been able to find a peice of blank
> >asbestos material to make another gasket from.  I don't even know
> >where
> >you would find a gasket for the warming plate on a stock Bugeye
> >exhaust
> >manifold.  Is there any other gasket material I can make this from?
> >Mike MacLean-60 Sprite
> >
>
> ___________________________________________________________________
> Get the Internet just the way you want it.
> Free software, free e-mail, and free Internet access for a month!
> Try Juno Web: http://dl.www.juno.com/dynoget/tagj.


<Prev in Thread] Current Thread [Next in Thread>