spridgets
[Top] [All Lists]

Fw: LCB header won't clear steering!

To: <spridgets@autox.team.net>
Subject: Fw: LCB header won't clear steering!
Date: Wed, 5 Feb 2003 16:34:22 -0500
ok i fudged the stupid trailer thing again!
read below!
chuck
----- Original Message -----
From "Charles Christ" <cfchrist at earthlink.net>
To: "Guy Weller" <guy@weller-lakes.freeserve.co.uk>;
<spridgets@autox.team.net>
Sent: Wednesday, February 05, 2003 4:33 PM
Subject: Re: LCB header won't clear steering!


> ya see the problem is a right hand designed header puts the center tube
> tight about dead center of the path of the steering shaft.   all this talk
> about bending it a bit is not going to make it fit as it will still hit on
> torque flex of the mounts.   it needs to be heated and bent or cut in
order
> to generate enough clearnace.   plain and simple it's a cut and weld
> situation , or heat it cherry red for a substantial length using a heating
> tip on a cutting torch and then "bend" it while hot.  dimpling it or
hitting
> it with a hammer will only damage (as well as trying to flex it into
> submission)the header and render it to a restrictive condition.   and at
> that point why did ya buy a header ?
>
> chuck

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets


<Prev in Thread] Current Thread [Next in Thread>