Are you guys talking about the splined section that allows the steering wheel
to be telescoped about 2 inches? The steering wheel hub does not engage that
part...
http://www.tigersunited.com/resources/wsm/wsmJ4.asp
Check the picture.
Cheers,
Theo
> -----Original Message-----
> From: tigers-bounces@autox.team.net [mailto:tigers-
> bounces@autox.team.net] On Behalf Of Sandy Ganz
> Sent: June 6, 2010 10:56 PM
> To: Would U. Believe; tigers@autox.team.net
> Subject: Re: [Tigers] Tiger Steering Wheel Spline(s)
>
> I'm going to have to yank it apart again, I think it had 2 distinct
> sections
> of splines, stepped if you will. The Grant Adapter and the Motolita
> adapter
> only slide on the first (top) spline set. It may be tapered but seemed
> more
> like a step to the second sized spline.
>
> 18mm = .709in which seems right for
> the hub which measures .711in inside diameter but I'm pretty sure the
> OD of
> the splines on the larger (lower) is looking like .75"
>
> Are alpine steering
> shafts the same?
>
> The car was in a fron ender at some point and that shaft
> could have been swapped out or something, but something doesn't seem
> right.
> Thanks for the info, going to have to open it up and look at it, will
> get a
> picture this time!
>
> Sandy
-----------------------------------------------------------------------------
---
This e-mail and any attachments may contain confidential material for the sole
use of the intended recipient. If you are not the intended recipient, please
be aware that any disclosure, copying, distribution or use of this e-mail or
any attachment is prohibited. If you have received this e-mail in error,
please contact the sender and delete all copies.
Thank you for your cooperation.
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|