[Tigers] Aluminum Radiator

[Brent Edinger <banana111@msn.com>]

I just installed an aluminum Fluidyne radiator and when it came time
to install the fan shroud I found the thickness of the new radiator
won't allow it to be installed. There is about a half inch gap between
the fwd edge of the shroud and the aft edge of the radiator support,
Any tricks to this? I built a little splice plate and It's installed but it
doesn't look good and I can see air will leak around over the top of the
radiator.

          Brent
_______________________________________________

tigers@autox.team.net

Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net