Jay
Glad you isolated the problem.
Accelerator pump leak now - it never ends but a good thing you saw it now.
Many times the accelerator pump cover screws have been over torqued and the
cover get warped; check it on a flat surface.
I had to put a cover in a press with some light pressure to flatten it. You
can also use some 400 grit or finer sandpaper on a flat surface to make the
cover's gasket face flat.
Ron Fraser
-----Original Message-----
From: tigers-bounces@autox.team.net [mailto:tigers-bounces@autox.team.net]
On Behalf Of Jay Laifman
Sent: Sunday, June 02, 2013 5:39 PM
To: Smit, Theo
Cc: tigers@autox.team.net Den
Subject: Re: [Tigers] Electrical problem - ignition/ballast resistor?
Well, the vast majority were correct. Bad battery. What a bummer. Lots of
work for nothing. At least I don't have to get in to replace the soleloid.
Too bad it's the most expensive part. Nevertheless, THANKS to everyone!
On the flip side, I noticed that the Holley is dripping gas out the bottom,
from what looks like an accelerator pump. Looks like the carb needs to come
out to service it. _______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.com
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2013.0.3343 / Virus Database: 3184/6371 - Release Date: 05/31/13
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|