After looking at my floorboards all weekend, I decided it was
easier to replace the inner, reinforcement plate, outer and floor-
board as one instead of trying to repair the rust. For you that have
done this, what do you use to prime the bare metal that will
be hidden, i.e. inside the rockers ? Also how do you support the
body when you take out the sills? I was thinking of cutting the floor
free from the sills but leaving in place until I get the sills in. Is a con-
tinuous seam better then spot welding?Lastly, should I drill the sills
and re-undercover when done. Thanks.
Mark (currently floorless)
|