There appears to be no power at the Green/black wire at the gas tank
sending unit. I assume that since there is out going power at the
voltage stabilizer, and that the temp gauge works (all in the same
circuit) that I have an open in the gauge???? Jerry Oliver
Malcolm Walker wrote:
>
> On Tue, 18 May 1999, Jerry Oliver wrote:
>
> > down?? Its been a couple of years, but I'm sure I check the sending unit
> > before buttoning up the tank. Should there voltage at the green wire at
> > the tank? The workshop manual suggested checking voltage at the
> > stabilizer. I had a brand new one, so I installed it...same problem.
>
> Take the 2 leads off the sending unit and short them together. Turn key
> to "on". Gas gauge should deflect ALL the way over. If it doesn't, you
> have a gauge problem. If it does, you have a float problem.
>
> -Malcolm
> * There is a FAQ for this list! Its temporary home is:
> http://www3.bc.sympatico.ca/walker/triumph/trfaq.htm
|