Hi
Look in the top and lift the lifting pin to see which bit moves then fill to
1/4" from the top of this, don't worry too much about over filling it will
disappear during use.
Graham.
----- Original Message -----
From: <VK0216@aol.com>
To: <triumphs@autox.team.net>
Sent: Wednesday, February 16, 2000 2:13 AM
Subject: A couple of simple but perplexing TR6 questions.
>
>
> I have just recently obtained my second 75 TR6. As I have read the
various
> posting the last couple of weeks, I am somewhat embarassed asking the
> following two questions.
> 1. How the heck do you get the various knobs (blower, defrost, heater,
etc)
> off of the shafts? Do you pull them, turn them, or what. I want to
replace
> them with new ones but I just can't seem to get the old ones off.
> 2. I have Stromberg 175 carbs. In accord with what I have read, if the
> dashpot oil is proper, you should feel pressure about 1/4 inch from the
> plastic cap entering the screw on. I bought dashpot oil and added just a
> little (not more than a teaspoon) and still couldnt visually see any
peering
> into the shaft. Anyway, I felt substantial pressure over and inch or so
from
> the cap entering the mechanism. Can anyone give me usable information in
> this regard.....thanks
>
|