Hi All
When I got home last night the brakes where again starting to seize.This
time
I slackened the two bolts holding the master cylinder to the servo and as
these
loosened I could here the brakes release.The problem was the rod from the
servo to the master cylinder was slightly longer than it should be.The end
of
the rod has an adjustment,however mine was seized so in the meantime I used
a couple of washers between the servo and master cylinder to increase the
distance.
I'm not happy about using this method but can't see any potential danger.Any
Thoughts?
Thanks to everyone who shared their thoughts.
Cameron
71TR6
Scotland
|