[Top] [All Lists]

Re: Tools for body sheet metal?

To: <>
Subject: Re: Tools for body sheet metal?
From: Cliff Hansen <>
Date: Wed, 05 Jul 2000 19:09:39 -0400
Hi all,

I certainly appreciate the advice.  I have a dremel and a cut-off tool; the
cut-off won't work up in the corner and the dremel, weeelll, I didn't want
to :-)

I'm considering an air-powered body saw, has a small hacksaw blade.
Harbor Frieght has it for $35.  I didn't look at the nibblers, I will when
I go

Thanks again.

At 11:37 AM 07/05/2000 -0400, David Massey wrote:
>Message text written by "Paul J. Burr"
>>Whoa! A dremel is fine for cutting rusted bolts, but large scale body
>It will take you a week to cut out a couple of square inches.<
>You are over stating the situation.  True an air powered cut off tool works
>more quickly but if you don't have an air compressor you will need a
>further investment.  And the Dremel tool is smaller and will fit in tighter
>environs.  Patience and a steady hand works wonders with a dremel too.
Cliff Hansen

<Prev in Thread] Current Thread [Next in Thread>