Dave
The plate is 3/8" in from the side and about 1 and 3/8" up from the bottom
(45 degree angle). Happy riveting......btw, what was in held in place there
by the DPO?
Dave Willner
59 TR3A (Apple Green)
70 BSA 441 Victor Special
Stroudsburg, PA
----- Original Message -----
From: "David Moag" <moag@ix.netcom.com>
To: "Triumphs Mailing List" <triumphs@autox.team.net>
Sent: Thursday, July 20, 2000 3:58 PM
Subject: TR3 Commission Plate Position
>
> Hello Listers,
>
> I need to know the proper location of the rivet holes for the TR3A style
> commission plate. The dreaded DPO had cut three huge circular holes into
> that portion of the bulkhead and I had to have a patch panel welded in to
> make things look (mostly) OK ... but in the process lost track of where it
> should be mounted.
>
> So if someone can measure where the two holes are in from the top, bottom,
> left, right, etc... then I can end up looking reasonably correct.
>
> THANKS!
>
> Dave Moag
> 62 TR3B (just about on the road!!!)
> 77 Spitfire
> La Canada, CA
>
>
>
|