To: | "list" <Triumphs@autox.team.net> |
---|---|
Subject: | tr3 body mounts to frame |
From: | "Randy Homanchuk" <rhomer@porchlight.ca> |
Date: | Wed, 12 May 2004 12:12:01 -0400 information |
Bill: on my tr3a the car orginally two aluminun spacers on the passenger side(one per mounting hole) with none the drivers side> if there were any rubber washer(s) they were not present at dissassembly.(likely rotted away) On another parts car the spacer arrangement was different again.Ibelieve the goal would be to have car supported on all body mounting locations,as no two car are exactly the same,while trying keep reference hieghts as close as coach built car can get??and most important holding your door gaps even Randy1960 tr3a |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Breaking in a rebuild engine (kinda longish), john matthews |
---|---|
Next by Date: | RE: Gluing dash veneer i4CGgLvL019615, Alvin Watkins |
Previous by Thread: | TR3 Body Mounts to Frame, Bill Brewer |
Next by Thread: | Re: TR6 turn signals, Mike Jackley |
Indexes: | [Date] [Thread] [Top] [All Lists] |