Kent,
Great story!? Try that repair with a modern car!
Aaron
Aaron Cropley
71 TR6 (Throttle Body Injection!)
http://www.triumphowners.com/108
Topsham, Maine
-----Original Message-----
From: Kent Shrack <kentshrack@yahoo.com>
To: steven@newellboys.com; triumphs@autox.team.net
Sent: Tue, 29 May 2007 8:53 am
Subject: [TR] Make your own gaskets
So, We're on our way to our home town Pratt Kansas on Saturday and the TR3
starts the sputtering. It feels like one of the carbs is not getting fuel, but
we stop in Emporia about 60 miles and I buy a coil as I'm really not sure, and
I
error on the electrical and the coil is really hot and oily on the outside. A
few more miles down the turnpike and it starts the sputtering again. I open
the
hood and fuel is dribbling out of the banjo type fitting holding on the fuel
bowl on the rear carb. I pull it apart and the rubber gaskets that hold the
fuel bowl are way out of shape and expanded from being old and in contact with
the gasoline. I try to re-assemble them but the gaskets are just too far gone.
Now beside the road with nothing for gaskets, Karen looks around and finds a
piece of a Semi truck tire. No way to cut that but we keep looking and find a
really nice Land Rover mud flap of about the right thickness. I use a socket
and my hammer to drive a round hole through
the flap and use my my wood chisel to make an octagon around the hole to make
a
gasket, and then make another, and put them on,, No leaks and we're on our way.
Ran great the rest of the weekend. I'll be buying gaskets soon. We put on
about 600 miles and all is well.
Kent Shrack
________________________________________________________________________
AOL now offers free email to everyone. Find out more about what's free from
AOL at AOL.com.
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|