[TR] torque wrench question

triumphs

[TR] torque wrench question

Subject:	[TR] torque wrench question
From:	tr3driver at ca.rr.com (Randall)
Date:	Fri, 10 Aug 2018 16:26:06 -0400
References:	<CANLCLaHs1mtOkE_mM_A-tYmfmW6zf1Qnj2QG5_q3ixtuJ-Bo8g@mail.gmail.com>

Depends on the angle between the crowfoot wrench and the torque wrench.

If you have it sticking out straight, then multiply the torque figure you want 
by the ratio of the torque wrench length divided by the new length. Both 
lengths measured from center of rotation to the center of the hand grip.

The formula for other angles is more complicated.
-- Randall
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/triumphs/attachments/20180810/03efdfc3/attachment.html>

[More with this subject...]

<Prev in Thread]	Current Thread	[Next in Thread>
[TR] torque wrench question, Sujit Roy [TR] torque wrench question, John Innis [TR] torque wrench question, Wbeech@flash.net [TR] torque wrench question, Randall <= [TR] torque wrench question, TERRY SMITH [TR] torque wrench question, Randall [TR] torque wrench question, TERRY SMITH [TR] torque wrench question, DAVID MASSEY [TR] torque wrench question, Peter Ryner [TR] torque wrench question, wbeech [TR] torque wrench question, Randall [TR] torque wrench question, John Innis [TR] torque wrench question, Wbeech@flash.net [TR] torque wrench question, Randall

Previous by Date:	[TR] Testing a J type OD, Randall
Next by Date:	[TR] Does people remember me?- Paul Dorsey, '60 TR3A, Matt
Previous by Thread:	[TR] torque wrench question, Wbeech@flash.net
Next by Thread:	[TR] torque wrench question, TERRY SMITH
Indexes:	[Date] [Thread] [Top] [All Lists]