Clutch Slave

From: Chris S. Mottram (Chris.S.Mottram(at)ecc.com)
Date: Tue Jul 01 1997 - 22:09:39 CDT

Next message: DSand95510(at)aol.com: "Re: harmonic balancers"
Previous message: Jarrid Gross (Yorba Linda, CA): "Re:"
Next in thread: Sergio Dimarmo: "Re: Clutch Slave"
Reply: Sergio Dimarmo: "Re: Clutch Slave"
Maybe reply: Chris Stephenson: "Re: Clutch Slave"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

From: Chris S. Mottram(at)ECCI on 07/01/97 11:09 PM

I yanked the clutch slave cylinder from my Series 5. The shop manual says
to expel the inerds by using compressed air. Not an option for me. Can I
poke a wooden dowel or screw driver in the brake fluid inlet hole to push
out the cylinder from within the slave?

Thanks,

Chris

Next message: DSand95510(at)aol.com: "Re: harmonic balancers"
Previous message: Jarrid Gross (Yorba Linda, CA): "Re:"
Next in thread: Sergio Dimarmo: "Re: Clutch Slave"
Reply: Sergio Dimarmo: "Re: Clutch Slave"
Maybe reply: Chris Stephenson: "Re: Clutch Slave"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 09:47:00 CDT