Re: Leaking side plate

From: Jay Laifman (Jay_Laifman(at)countrywide.com)
Date: Fri Nov 21 1997 - 16:52:44 CST

Next message: Miles: "Re: alpines(at)autox.team.net digest #510 Fri Nov 21 04:05:01 MST 1997"
Previous message: Jarrid Gross (Yorba Linda, CA): "Re: Leaking side plate"
Maybe in reply to: Jay Laifman: "Leaking side plate"
Next in thread: Jarrid Gross (Yorba Linda, CA): "Re: Leaking side plate"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Ok, so how much will you charge for one?

GROSS(at)UNIT.COM on 11/21/97 02:44:00 PM

To: Christopher.Albers(at)bubbs.biola.edu, Jay_Laifman(at)countrywide.com
cc: alpines(at)autox.team.net (bcc: Jay Laifman/Legal/CF/CCI)
Subject: Re: Leaking side plate

Jay_Laifman(at)countrywide.com,Internet writes:
> What someone needs
>to make is a thick hard piece of metal that will fit in the side plate
>and
>act as one big washer to spread the load of each bolt and keep the
plate
>from warping.

Done,
My new 1725 race motor uses a plate of aluminum with fittings for
an oil catch tank.
Easy to make, and you can tighten the heck out of it.

Jarrid

Next message: Miles: "Re: alpines(at)autox.team.net digest #510 Fri Nov 21 04:05:01 MST 1997"
Previous message: Jarrid Gross (Yorba Linda, CA): "Re: Leaking side plate"
Maybe in reply to: Jay Laifman: "Leaking side plate"
Next in thread: Jarrid Gross (Yorba Linda, CA): "Re: Leaking side plate"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:02:43 CDT