Fellow Alpiners,
I recently procurred an overdrive for my 66 SV Alpine while visiting my
brother in Florida.
I am currently looking for the correct transmission output shaft to
install in my 4sp gearbox so I can get the overdrive installed. An
overdrive would be preferable (and...easier on the ears) for the ride to
Big Sky Montana this summer.
1) Does anyone out there have the correct transmission output shaft
they would like to part with?
2) Does anyone have a bent output shaft I could use for duplication
purposes?
3) Does anyone know where I could get my hands on a (Rootes?) print for
this part so I could get one machined and heat treated?
In following the listing for the last 2 yrs it sounds like quite a few
of these shafts have been bent.
Any help would be greatly appreciated!
Thanxs,
Bob Flak
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:44:21 CDT