Re: Transmission overdrive output shaft

From: Jay Laifman (Jay_Laifman(at)countrywide.com)
Date: Tue Apr 06 1999 - 10:05:01 CDT

Next message: Jay Laifman: "Starting a newly rebuilt engine"
Previous message: Ron Tebo: "Unhooked Ammeter"
Maybe in reply to: Bob Flak: "Transmission overdrive output shaft"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Are you looking for the shaft inside of the transmission or the driveshaft?
You do not need any special drive shaft. Your standard course spline drive
shaft can easily be cut down and balanced by a local shop that works on
drive shafts. If it is the internal shaft, good luck. From what I
understand, they are not available separate from an actual OD transmission
joined to an OD.

Jay

Next message: Jay Laifman: "Starting a newly rebuilt engine"
Previous message: Ron Tebo: "Unhooked Ammeter"
Maybe in reply to: Bob Flak: "Transmission overdrive output shaft"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:44:28 CDT