[Top] [All Lists]

RE: figure 8 gaskets

To: "''" <BillDentin@AOL.COM>,
Subject: RE: figure 8 gaskets
From: Jack Wheeler <>
Date: Thu, 28 Oct 1999 10:23:46 -0500
Bill, I guess, theoretically, you could 'custon fit' the thickness of the 
gasket to the heighth of the liner to get each liner protruding the correct 
amount.  This would require having various thicknesses of gaskets on hand. 
 I think it would be easier to find a set of liners that match.

-----Original Message-----
From: []
Sent:   Thursday, October 28, 1999 8:41 AM
Subject:        Re: figure 8 gaskets


Maybe that will work, but assuming the problem is liners that do not match, 
don't you HAVE to use stacks of gaskets.  We had no choice but to use
'stacks' of figure eight gaskets.


<Prev in Thread] Current Thread [Next in Thread>