land-speed
[Top] [All Lists]

Re: Head Gaskets

To: Tom Neimeyer <3cbxs@ev1.net>
Subject: Re: Head Gaskets
From: tim schoeny <tschoen@fuse.net>
Date: Thu, 15 Mar 2001 06:46:57 -0500
Been running the FelPro Permatorque(? sp) gasket and ARP studs for three years
with no problems.No sealers and no or very little surface clean up when removing
head.The studs take it easy on the aluminum head(big washers) and provide nice
even torque.I've checked torque several times after running and it stays right
on.

Tom Neimeyer wrote:

> Keith,
>   Do you coat the head gaskets with anything?  What about O-ringing?  What
> about everybody else?
>
> Regards, Tom
>
> ----- Original Message -----
> From: "Keith Turk" <kturk@ala.net>
> To: "Dick J" <lsr_man@yahoo.com>; <land-speed@autox.team.net>
> Sent: Wednesday, March 14, 2001 1:27 PM
> Subject: Re: Head Gaskets
>
> > Dick we ran a .018 on the Cast Iron D motor in the beginning... then we
> > realized we ain't drag racing....Head seal is an important issue .... we
> > been running Felpro and Ferrera gaskets and both seem to be fine even with
> > the extra Push they get from a bit of Nitrous....
> >
> > Keith
> >
> > ----------
> > > From: Dick J <lsr_man@yahoo.com>
> > > To: Keith Turk <kturk@ala.net>; land-speed@autox.team.net
> > > Subject: Head Gaskets
> > > Date: Wednesday, March 14, 2001 12:34 PM
> > >
> > > I opened up my Chubby Small Block last night and
> > > found something I'm not used to.  Every head
> > > gasket I've ever seen on a modern V-8 has been a
> > > composite type thing with crush rings around the
> > > cylinders.  What I found under these heads were
> > > two thin (.030 - .040) sheets of metal, possibly
> > > steel or stainless steel.  I've seen copper head
> > > gaskets for flatheads before, but have never run
> > > across this type of steel shim gasket on an OHV
> > > V-8.  Ought to be good for a little compression
> > > ratio boost, but what else should I know? They
> > > apparently can be re-used since nothing happens
> > > to them when they are installed?  Do I use some
> > > kind of goop or something when I put the heads
> > > back on?  Should I use standard torque specs?
> > >
> > > =====
> > > Dick J
> > > In East Texas
> > > Yahoo! Auctions - Buy the things you want at great prices.
> > > http://auctions.yahoo.com/

///
///  land-speed@autox.team.net mailing list
///


<Prev in Thread] Current Thread [Next in Thread>