mgs
[Top] [All Lists]

Re: Kingpin Bushings

To: Rich_and_Kerry@compuserve.com
Subject: Re: Kingpin Bushings
From: britcars@juno.com (Lawrence J Alexander)
Date: Tue, 26 Aug 1997 12:18:49 EDT
On Mon, 25 Aug 1997 23:05:53 -0400 Richard Peterson
<Rich_and_Kerry@compuserve.com> writes:

>As you may have guessed, I'm contemplating rebuilding the kingpins in 
>my
>'77 B and would like some advice on methods of reaming the bushings.  
>I
>don't have access to the factory tool, but thought about using a brake
>cylinder hone to size the bushings to the appropriate dimensions once
>they're installed.  Has anyone tried this??  Will I have nightmares 
>when I go to insert the kingpins??  What other methods are available, if
any, 
>to do this?

Richard....Using a brake hone presents two major problems: one, the hone
would take a really long time to remove enough material for you to fit
the king pin. As if this weren't bad enough, when you'd finally made the
holes big enough, you'd discover that the two holes no longer had the
same center line and you'd have to take out even more material to get the
king pin to go through both of them. Then you'd have a pair of bushings
in worse shape than when you started......

Don't do it! Have the bushes reamed by someone with the proper tool.
You're located pretty close to University Motors, aren't you?  I'm sure
they'd do it for you.

Lawrie 
British Sportscar Center

<Prev in Thread] Current Thread [Next in Thread>