I recently tried to start my newly built-again MGB
engine (built on a new block this time). However,
after a lot of starting, I could not get any oil
flow or pressure.
I don't think that I used the wrong gasket from
the gasket set; I took a picture of the one I did
NOT use; it's at
http://www2.msstate.edu/~mts3/gasket.jpg. I was
turning the engine over with no spark plugs in and
throttle open, so it was spinning fast for a long
time. No oil flow at the pressure relief valve
and at the filter.
Any ideas before I pull the pan (engine in the
car)?
Thanks,
--
Tyson Sherman
mts3@ra.msstate.edu
ICQ# 10494960
http://www.tecinfo.com/~tsherman
|
