Typically cut as close to the weld line using something like a nibbler
(impact cutting can cause distortion, although that is more of a potential
problem with external panels) then grind off with an angle grinder of a
suitable size. Shouldn't have much left after that.
----- Original Message -----
From: "Matthew Hale" <haleme@bellsouth.net>
To: <mgs@autox.team.net>
Sent: Thursday, October 24, 2002 3:18 AM
Subject: Replacing floor boards and other things
> ... The floorboards
> in my 67 B are way beyond bad and I am going to replace them. I have an
> angle grinder and have used this to successfully re-skin the doors and
> other parts, so I feel comfortable using this tool. I am not sure how
> to remove the floor board from the cross member. How does one go about
> removing bad parts welded to good parts and not damage the good parts?
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|