[Top] [All Lists]

Re: Rear fender question

To: "Matthew Hale" <>, <>
Subject: Re: Rear fender question
From: David Councill <>
Date: Wed, 11 Dec 2002 21:20:38 -0700
I used the half sections. Hopefully, you can make sense of my description. 
The piece goes all the way back to the tail light and includes the area on 
the outside part of the tail light. You will also notice the vertical seam 
below the tail light - that is where the piece will go to  on the lower 
end. It should pretty much cover everything below the trim attaches on the 
side. I'm not sure how you weld it into place however. I had a body shop do 
that part for me, but I was pondering exactly how they did it. With the 
wheel well being the way it is, do you remove the top section to weld the 
bottom section on? Perhaps someday I will know the answer to that (maybe 
sooner if someone from the list pipes in).

David Councill
67 BGT
72 B

At 10:23 PM 12/11/2002 -0500, Matthew Hale wrote:
>I am debating over which rear fender replacement sections to buy for my
>67 B.  I am replacing the entire rear panel and want to replace the
>wheel arches, dogleg sections and the bottom of the tail lights.  The
>simple answer would be the Half Sections from Moss (457-960, 965).  But
>it is not that simple because I don't how far the section covers from
>the tail light to the rear panel.  Has anyone used these replacement
>parts on their B?  I hope I am being clear.  Moss Motors didn't
>understand me either.  They told me call back during business hours to
>talk to someone in the warehouse.
>Matthew Hale
>67 B
> <>

///  or try
///  Archives at

<Prev in Thread] Current Thread [Next in Thread>