I'll start by admitting I did something wrong. I just don't know what!
I am putting my rear end back together and as I was installing the axle seal
the little springs that goes around the inside of the rubber seal came out.
I was using a bearing\seal installer (handle with big flat aluminum disc
I guess I hit it too hard. The worst thing is it happened on both sides. I
can't seem to force the springs back into the inside groove of the rubber.
Now I have to get a seal removing tool to get these out and get new ones. I
don't want to screw the new ones up.
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959