That's what everybody tells me but it will not work on mine.
Larry
-----Original Message-----
From: Mike Gigante <mikeg@vicnet.net.au>
To: Larry and Sandi Miller <millerls@msn.com>; David Christman
<dpc@ai.mit.edu>; spridgets@autox.team.net <spridgets@autox.team.net>
Date: Tuesday, December 08, 1998 8:37 PM
Subject: Re: Radiator Stuff
>I have a crossflow in my rally bugeye. It does fit. I didn't do the fitting
>but look at it, there doesn't seem to be anything obvious that has changed.
>
>Mike
>
>-----Original Message-----
>From: Larry and Sandi Miller <millerls@msn.com>
>To: David Christman <dpc@ai.mit.edu>; spridgets@autox.team.net
><spridgets@autox.team.net>
>Date: Tuesday, December 08, 1998 7:56 PM
>Subject: Re: Radiator Stuff
>
>
>>A downflow measured at the cap is about 19". A crossflow measured at the
>>upper back of the shroud is about 16". Both are about 16 1/2' wide at the
>>mounting flange.
>>
>>Installed in the car, a crossflow sits about 1' higher at the front than
>the
>>downflow does. This is measured from the ground to the top of the bolt
>>through the top of the shroud into the radiator.
>>
>>The crossflow will not fit in either of my Bugeyes. The bonnet hits the
top
>>of the radiator and will not close.
>>
>>Based on the numbers, yes it would fit. But based on my experience with
>the
>>crossflow it would depend on other things involved in the mounting.
>>
>>Larry
>>
>>-----Original Message-----
>>From: David Christman <dpc@ai.mit.edu>
>>To: spridgets@Autox.Team.Net <spridgets@Autox.Team.Net>
>>Date: Tuesday, December 08, 1998 6:33 PM
>>Subject: Re: Radiator Stuff
>>
>>
>>>I just measured the radiator from a 90 Suzuki Swift 1.3L 4-cyl. It
>>>was 18" high (very bottom to top of cap) and 14" wide. Would this
>>>fit in spridget? Mine is packed away for the winter.
>>>
>>
>>
>>
>
>
|