I used the runners that cobra sold.. they have fore and aft movement..AIMHO
are a lot safer than thee rootes sunners as the seat doesnt hinge forward so
wont throw you in a hit. Also apart from the side bolsters holding you in in
the corners, the fact the seat is secure to the floor on all 4 corners means
it doesnt lean either.. feels much more solid.
Also.. i didnt go for the optional headrests as they are too short to do
anything.. now.. to throw in another option.. and a lot more pricey.. but
there are replca porsche RS carerra seats from GTS that i htink are even
nicer.. but cost a fair bit more:
though iwould not sue the head rests...
On 14 July 2010 10:48, Sandy Ganz <email@example.com> wrote:
> Thanks all so far for the seat suggestions. Michael was the one that I
> was looking for. I like the look of that seat, still looks vintage. The
> width of the Cobra Classic was 19.3" and the wide point and I think the
> Corbeau's were right at 19" as well. I'll have to get some measurements
> I may be removing the console and that might allow some wiggle room but
> will have to get the tape measure out tonight.
> Also Michael, what did you do to mount those seats, did you use the Sunbeam
> rails or new brackets to mount the seats? And same question Larry ;)
> Thanks a bunch for the feedback!
> *From:* michael king <firstname.lastname@example.org>
> *To:* "Smit, Theo" <Theo.Smit@dynastream.com>
> *Cc:* Sandy Ganz <email@example.com>; "firstname.lastname@example.org" <
> *Sent:* Tue, July 13, 2010 3:45:57 PM
> *Subject:* Re: [Tigers] Turn Signals, Steering Wheels and Seats
> I used the cobra classic bucket, which from what i can tell is almost the
> same as the corbeau classic seat.. the one you have shown looks a little
> wide.. here is a picture of the bucket in my alpine SII.
> On 14 July 2010 07:15, Smit, Theo <Theo.Smit@dynastream.com> wrote:
>> Check the base measurements on that seat... I'm not sure that it will fit
>> to side. They have the original Classic that is an inch narrower, but even
>> that one might be a squeeze to get in there. IIRC, the Tiger rails are
>> not symmetric with respect to the seat centerline so some adapting is
>> From: email@example.com [firstname.lastname@example.org] On
>> Of Sandy Ganz [email@example.com]
>> Sent: Tuesday, July 13, 2010 12:48 PM
>> To: firstname.lastname@example.org
>> Subject: [Tigers] Turn Signals, Steering Wheels and Seats
>> Tiger Fun -
>> And now an actual question!
>> Anyone use Corbeau seats in their tiger? I was looking at the Classic II
>> and want something that I can drop onto the tiger rails without too much
>> and that don't like like seats from a Honda Civic Racer.
>> This e-mail and any attachments may contain confidential material for the
>> use of the intended recipient. If you are not the intended recipient,
>> be aware that any disclosure, copying, distribution or use of this e-mail
>> any attachment is prohibited. If you have received this e-mail in error,
>> please contact the sender and delete all copies.
>> Thank you for your cooperation.
>> Donate: http://www.team.net/donate.html
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
> Michael King