I think the other thing you need to look at is the track width of the donor
vehicle. I recall looking into the newer trucks as donors but ruled them
out because they were too wide. Just something to look at, my memory does
fail from time to time.
Missouri City, Texas
> -----Original Message-----
> From: Bob Fischer [SMTP:email@example.com]
> Sent: Wednesday, September 08, 1999 1:25 PM
> To: firstname.lastname@example.org
> Subject: Re: [oletrucks] Advance Design front end mods
> Hi Mark, all,
> >>>Good IFS subframe donor vehicles:
> >>> '73 thru '87 Chevy/GMC fullsize 1/2 ton 2wd truck (thru '89 Chevy/GMC
> >>>Suburban 1/2 ton 2wd) complete front suspension and steering. The later
> >>>truck suspension/steering just unbolts. The difference between the
> >>and the later frames is the advanced design frame is .5 (1/2) inch
> narrower on
> >>>each side than the front suspension saddle and needs to be shimmed by a
> >>>spacer (the same for the steering).
> >> I went to the wrecking yard, but, when I measured the frame, it
> >>appeared that this truck has a frame that is 29 1/2" wide while my '55
> >>appears to be 25". I hope I can use this front end.
> I went and crawled under ours this morning and checked between the bottom
> of the channel just above the axle. It appears to be slightly over 28"
> maybe +1/4" - 1/2"
> which would fit approx what JP stated "1/2" shim each side."
> Did you measure between the front rails where the bumper is attached? My
> there is 25", so the frame rails taper together past the front axle near
> the radiator support.
> I'll have to go to a yard and find a couple trucks around 77 and check.
> Sure hope this pans out.
> "Nothin lasts forever except old Fords and a natural stone" - Willie
> http://home.utm.net/bfischer e-mail - email@example.com
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959