spitfires
[Top] [All Lists]

Re: clutch slave cylinder

To: Sam Gentry <hsgentry@cfw.com>
Subject: Re: clutch slave cylinder
From: Joe Curry <spitlist@gte.net>
Date: Sat, 04 Jul 1998 19:08:08 -0700
Sam,
Sounds like a good possibility for the "tips" section of the Spitfire
Database!

Joe

Sam Gentry wrote:
> 
> By the way, anyone else who has killed a slave by following the Haynes
> instructions to remove the cap has lots of company.  I had emails from no
> less than 5 folks who said that they had done the same thing.  This one
> makes 6.
> 
> Sam
> 
> At 08:34 PM 7/4/1998 -0400, GatesDavid@aol.com wrote:
> >I have the same problem as Sam.  I was just getting ready to pull my engine
> >and in the process took the slave cylinder out.  The cap is messed up just
> >like his.  I have been leaking fluid since I got the car but never had the
> >chance to check the slave yet.  When I purchased the car the DPO (the "P"
> does
> >stand for previous) said that he had just rebuilt the slave, thanks alot.  Is
> >there any way to get a new cap for this or do I have to buy a hole new
> >cylinder just for the cap.  The rebuild kit obviously does not have one in
> it.
> >Just for future reference is there a way to get this cap off without
> >destroying it?  The Haynes manual just says to remove it but does not go into
> >any more detail.
> >
> >
> >In a message dated 6/17/98 1:02:57 AM Hawaiian Standard Time,
> hsgentry@cfw.com
> >writes:
> >
> >> Subj:        Re: clutch slave cylinder
> >>  Date:       6/17/98 1:02:57 AM Hawaiian Standard Time
> >>  From:       hsgentry@cfw.com (Sam Gentry)
> >>  Sender:     owner-spitfires@autox.team.net
> >>  Reply-to:   hsgentry@cfw.com (Sam Gentry)
> >>  To: spitfires@autox.team.net
> >>
> >>  I should have stated that this cylinder is from a 72 Spitfire MK IV.
> >>
> >>  Sam
> >>
> >>  At 09:47 PM 6/16/1998 -0400, Sam Gentry wrote:
> >>  >I just discovered that the DPO damaged the metal cap on the end of the
> >>  >clutch slave cylinder when he disassembled it.  The cap like piece that
> >>  >holds the rubber seal for the push rod.  does anyone have one of these or
> >>  >even a non-repairable slave cylinder that could donate one.  Maybe even a
> >>  >repairable slave.  Not bad to have a spare.
> >>  >
> >>  >Oh. . . I must confess. . . DPO is not Dumb Previous Owner, but Dumb
> >>  >Present Owner.
> >>  >
> >>  >Sam
> >>  >
> >

-- 
"If you can't excel with talent, triumph with effort."

 -- Dave Weinbaum in National Enquirer

<Prev in Thread] Current Thread [Next in Thread>